Cannabis Feeding Chart and Schedule for Soil, Coco and Hydro
Every nutrient brand prints its own feeding chart, and every chart assumes the plant, the pot and the room you do not have. What you actually need is a neutral starting table per medium: how strong, how often, what pH, for each stage. The tables below give that, and the last sections show how to adjust them from the plant instead of the calendar. They are starting ranges, not rules; your brand's label and your plant's response outrank any chart, including this one.
Step one: pH by medium
Strength means nothing if the roots cannot take the nutrients up, so pH comes before the chart. Measure the pH of the solution after mixing the nutrients, because the nutrients themselves move it.
| Medium | Solution pH | Why |
|---|---|---|
| Soil | 6.0-7.0 | Soil buffers pH and microbes help uptake, so the window is wide |
| Coco coir | 5.5-6.5 | Inert medium behaves like hydro for pH |
| Hydro (DWC, NFT, ebb and flow) | 5.5-6.5 | Roots sit in the solution, so a drift shows within a day |
Soil feeding chart
Good potting soil comes with food, so soil growers feed as a share of the label dose rather than chasing an EC number, and many never own an EC meter. Start low, raise the dose only when the plant asks for more, and water between feedings with plain, pH-adjusted water. If you do measure, an input of roughly 0.8 to 1.6 mS/cm covers most of the cycle.
| Stage | Typical weeks | Nutrients | Share of label dose | How often |
|---|---|---|---|---|
| Seedling | 1-2 | None, or a very light feed | 0-25% | Water only, feed at most once |
| Early veg | 3-4 | Grow or balanced formula | 25-50% | Every 2nd or 3rd watering |
| Late veg | 5-6 | Grow formula, add Cal-Mag if needed | 50-75% | Every 2nd watering |
| Stretch (first 3 weeks of flower) | 7-9 | Switch to bloom formula gradually | 50-75% | Every 2nd watering |
| Mid flower | 10-14 | Bloom formula, bloom booster if you use one | 75-100% | Every 2nd watering |
| Late flower | 15-16 | Bloom formula only | 50-75% | Every 2nd to 3rd watering |
| Finish | Last 1-2 weeks | Plain pH-adjusted water, or per your brand | 0% | Water only |
Coco coir feeding chart
Coco holds almost no nutrients of its own and is usually fed at every watering, with a runoff of 10 to 20 percent so salts do not build up. It binds calcium and magnesium, so most coco feeds include Cal-Mag or a coco-specific base. Figures are input EC in mS/cm, measured in the solution you pour, not in the runoff.
| Stage | Typical weeks | Input EC (mS/cm) | ppm on the 500 scale | pH | How often |
|---|---|---|---|---|---|
| Seedling | 1-2 | 0.4-0.8 | 200-400 | 5.8-6.0 | Light feed every watering |
| Early veg | 3-4 | 0.8-1.2 | 400-600 | 5.8-6.0 | Every watering |
| Late veg | 5-6 | 1.2-1.6 | 600-800 | 5.8-6.0 | Every watering |
| Stretch | 7-9 | 1.6-2.0 | 800-1000 | 5.8-6.0 | Every watering |
| Mid flower | 10-14 | 1.8-2.2 | 900-1100 | 5.8-6.2 | Every watering |
| Late flower | 15-16 | 1.4-1.8 | 700-900 | 5.8-6.2 | Every watering |
| Finish | Last 1-2 weeks | 0.0-0.6 | 0-300 | 5.8-6.2 | Plain water or a very light feed |
Hydro feeding chart
In hydro the roots live in the solution, so the reservoir is the chart: you control EC and pH directly, and you watch both daily. The ranges below are the same stage corridors GrowScope uses for hydroponic tanks, drawn from the General Hydroponics FloraSeries and CANNA Aqua schedules; they are deliberately wide because manufacturers differ. Passive systems and aeroponics are usually run a little weaker than deep water culture.
| Stage | Typical weeks | Reservoir EC (mS/cm) | ppm on the 500 scale | pH | Reservoir change |
|---|---|---|---|---|---|
| Seedling or clone | 1-2 | 0.4-1.2 | 200-600 | 5.5-6.2 | Weekly |
| Vegetative | 3-6 | 0.9-2.0 | 450-1000 | 5.5-6.2 | Every 1-2 weeks |
| Flower (stretch to mid) | 7-14 | 1.4-2.4 | 700-1200 | 5.5-6.2 | Every 1-2 weeks |
| Finish | Last 1-2 weeks | 0.6-1.8 | 300-900 | 5.5-6.2 | Fresh tank, ending on low EC |
Reading EC: mS/cm, ppm and runoff
EC is reported in mS/cm (or dS/m, the same number), while many meters show ppm, and ppm depends on the scale: multiply mS/cm by 500 for the 0.5 scale, by 640 or 700 for the other common ones. Pick one scale and never mix charts that use different ones. In soil and coco, also measure the runoff EC: it tells you what the roots are actually sitting in. Runoff much higher than input means salts are building up, so cut the dose or give a plain water run; runoff much lower means the plant is eating more than you give. GrowScope applies a rule like this one: runoff at 1.3 times the input twice in a row suggests a dose 20 percent lower, 1.6 times or more suggests plain water, and 0.7 times or less suggests 10 percent more.
How to use the chart without it burning the plant
Run the chart as a hypothesis. Start one step below the table, move up a step each week only when new growth is a healthy green, and stop climbing at the first sign of burnt tips, a very dark green or clawed leaves. Pale, uniform yellowing of lower leaves while growth slows says the plant wants more; crispy tips on new growth say it already has too much. Write every feeding down - date, product, EC, pH, runoff - so a problem a week later can be traced to a cause. Autoflowers are smaller and less forgiving of overfeeding, so stay at the low end of every range.
Feeding schedule template
Copy the skeleton, fill in the dose from your brand's label and the table for your medium. Soil: water, then feed, then water, repeating, with the dose rising by stage. Coco: feed every watering, pH 5.8 to 6.2, aim for 10 to 20 percent runoff, check runoff EC once a week. Hydro: check EC and pH every day, top up with plain water to the target volume, change the reservoir on its schedule. In all three, log the numbers, because the log is what turns a chart into a schedule that fits your plant.
Do it in GrowScope: a feeding calendar for your own products
GrowScope builds the full-cycle feeding calendar from your strain, pot size, substrate and the fertilizers in your cabinet, with feeding, watering and flush days colour-coded across the month, and it spends no AI credits to do it. You can add a product by photographing its label, and the app computes the day's dose so two fertilizers on one day share one safe strength. Runoff EC feeds back into the suggested dose, and nothing changes until you tap to apply it. Hydro tanks have their own EC and pH targets by stage. You can start free with one plant.
How GrowScope helps
GrowScope builds a full-cycle feeding calendar from your strain, pot, substrate and fertilizer cabinet without spending AI credits, shares one safe strength between fertilizers on the same day, and uses runoff EC to suggest the next dose. Start free with one plant.
Key takeaway
Use the soil, coco or hydro table as a starting point: set pH first, start one step below the chart, climb only while new growth stays healthy, and log EC, pH and runoff at every feeding so the chart becomes your own schedule.