Skip to content
GrowScope
Open app

Autoflower Feeding and Light Schedule

Autoflowers run on a short clock, so they punish both overfeeding and slow decisions. The template below puts light, feed strength and EC on one table by week. Treat it as a starting point and keep to the low end of each range; the plant is small and less forgiving than a photoperiod plant.

Light schedule

Autoflowers do not need a light change to flower, so the light stays the same all cycle. Most growers run 18 hours on and 6 off; some run 20 on and 4 off, which adds light but also heat and power cost. What changes is intensity, not hours.

Autoflower light by stage
WeeksStageHoursPPFD at canopyVPD (kPa)
1-2Seedling18180-3200.6-0.9
3-4Veg18350-5500.8-1.1
5-9Pre-flower and flower18550-8001.2-1.5
10-12Finish18450-6501.2-1.4

Feeding schedule

Feed strength follows the plant's size. Soil is shown as a share of the label dose; coco as input EC in mS/cm. If a leaf tip burns, step back one row and hold.

Autoflower feeding by week
WeeksSoil (share of label dose)Coco input EC (mS/cm)pH (soil / coco)Notes
1-2None0.4-0.86.0-7.0 / 5.8-6.0Water in a widening circle
3-425-50%0.8-1.26.0-7.0 / 5.8-6.0Start feeding, add Cal-Mag in coco
5-650-75%1.2-1.66.0-7.0 / 5.8-6.0Switch to bloom as pistils appear
7-975-100%1.6-2.06.0-7.0 / 5.8-6.2Peak demand, keep logging
10-12Reduce1.0-1.4, then plain water6.0-7.0 / 5.8-6.2Trichome checks, plan the last feed

Mistakes that cost autoflowers yield

Three mistakes account for most lost autoflower yield. Overfeeding: the small root mass cannot use a full-strength schedule, and burnt tips mean the dose was too high. Stress during veg: topping late, transplanting after week two or heavy defoliation uses time the plant does not have; stick to gentle training and plant in the final pot. Starting late: because the clock runs from the sprout, every week lost early is a week of growth lost, so keep the climate on target from day one.

Do it in GrowScope

Choose autoflower as the plant type and GrowScope builds a calendar with the shorter cycle and the lighter stage corridors for it, so feeding, watering and flush days are laid out for the real plant rather than a photoperiod template. You can start free with one plant.

How GrowScope helps

GrowScope builds the calendar for an autoflower with its own stage corridors for light and VPD, and lays out the feeding, watering and flush days. Start free with one plant.

Key takeaway

Run 18/6 all cycle, raise PPFD by stage, start feeding at 25-50% of the label dose in week three, peak around weeks seven to nine and stay at the low end of every range because autoflowers are small and unforgiving.