Skip to content
GrowScope
Open app

Nutrient and pH Down Calculator: Doses for Any Tank

Mixing a tank takes three small calculations: how much of each product, how much pH down, and what the resulting EC should read. None is hard, but each goes wrong in a predictable way. This guide gives the arithmetic, a quick lookup table and a sample method for pH down, the one number you cannot calculate in advance.

Embed this tool on your site
<iframe src="https://growscope.uk/embed/nutrient-mix-calculator.html?lang=en" title="Free nutrient and pH down calculator - GrowScope" style="width:100%;max-width:480px;height:860px;border:none;" loading="lazy"></iframe>
See all free tools →

Nutrient dose: per litre, then per tank

Labels give a dose per litre, such as 2 ml per litre. The amount for a tank is the dose times the volume: 2 ml per litre in a 12 litre tank is 24 ml. If you feed at a share of the label dose, multiply by that share first: half strength of 2 ml per litre is 1 ml per litre, which is 12 ml in the same tank. Mix products in the order the label says, and add each to water, not to each other.

Total product per tank (ml) for common doses
Dose (ml/L)5 L10 L20 L50 L
0.52.551025
15102050
2102040100
3153060150
4204080200

Several products and several plants

Two points trip people up. First, bases from different product lines are not meant to be added at full strength each, so two bases in one tank share one full strength; additives and stimulants keep their own full rate. Second, when one tank feeds several plants, the concentration is the same for all and only the portion differs, in proportion to how much water each plant needs.

pH down: there is no universal amount

The amount of pH down depends on how alkaline your water is and on what nutrients you added, so a table would mislead. Use a sample instead. Add the nutrients first, because they shift the pH. Take one litre of the finished solution, add pH down one drop at a time, stir, count the drops and read the meter. Scale up: if five drops take the litre from 7.2 to 5.9, then a 10 litre tank needs about 50 drops, added in two or three steps with the meter read after each. Correct in small steps and wait a minute or two before rereading. Never go below the target and then correct up with pH up, since that adds salts.

EC and ppm

A meter may show mS/cm or ppm. Convert with the scale your meter uses: multiply mS/cm by 500 for the 0.5 scale, or by 640 or 700 for the other common scales. So 1.6 mS/cm is 800 ppm on the 500 scale, 1024 on the 640 scale and 1120 on the 700 scale. Use one scale throughout, and subtract your source water's EC when you want the contribution of the nutrients alone.

Do it in GrowScope

GrowScope has a fertilizer calculator for several plants, several products and one tank: it works out the dose per litre and the total for the tank, shares one full strength between bases of different lines while additives keep their full rate, and splits the finished solution between plants in proportion to their watering volume. The pH down amount is a manual step, as above. You can start free with one plant.

How GrowScope helps

GrowScope calculates the dose for a tank with several products and plants, shares one full strength between bases and splits the solution between plants by watering volume. Start free with one plant.

Key takeaway

Tank dose = label dose per litre x litres x your share of the label dose; find pH down by sampling one litre and scaling up, adding nutrients first; and convert EC to ppm with the scale your meter uses.